Tool bits notes

Carbide tipped

DIN4981 – Grooving/parting
DIN4975 – Pointed straight turning
DIN4977 – Facing
DIN4974 – Internal corner turning
DIN4972 – Right and left hand turning tool



WN 407R (?) – Grooving/parting
DIN4953 – Boring
DIN4955 – Pointed straight turning
DIN4960 – Right and left side turning
DIN4952 – Left and right bent turning


Replacement electronics for the Quacker

The current electronics are not robust enough. In moving the components over to the new housing, things are coming apart, soldered connections are failing, etc. There’s not really enough space in the box so everything’s crammed in and nothing has any strain relief so the cramming-in is causing failures.

There are two options:

  • Replace the current nest of wires with a custom-made shield.
  • Replace the entire thing with a standalone Arduino – one board that includes all the supporting circuitry

Either way, I think I should also move away from the two relays currently used to control the bang and the siren and just use transistors instead – I’m not sure why I didn’t do that the first time.

The schematic I have is not actually right as the indicator light has a voltage doubler to bring it closer to the required 24V. I should make a new one.

No data sheet for the central locking actuator and nothing much came up on googling. Attempted to measure peak curtent with multimeter that has no peak function… the highest value I saw was about 2.5A, so let’s assume 3A@11.1V. This probably requires a MOSFET to switch.

Siren is 350mA@12V according to the datasheet.


Infra-red detection research

  • Acrylic infra-red filters (data sheet)
  • There are infra-red sensors but they are what is used in PIR detectors, they are expensive (£2.50 a go) and seem to require fairly complex supporting circuitry
  • There are also infra-red receivers for remote controls. They are cheap and combine a sensor (perhaps a phototransistor?) with a pre-amp, and include daylight filtering. Possibly a good bet. Example (data sheet).
  • Finally, bare phototransistors. Very cheap. From the datasheet it looks like they might allow more current to pass when exposed to more IR, which might be useful. Example (data sheet).

I tested a small solar panel by exposing it to IR, there was no difference at all in the voltage it produced. Though possibly other panels may work.

Light fixture

Love the flex being tied over to secure the light. And the rest of the fitting is wood, mitred, and then weathered. There’s a bead of caulk (or something) along the edge of the middle section, looks a bit like old welding. Not sure if deliberate…